Recuperator for Vallox ValloMulti 200 SB
Replacement exchanger for Vallox ValloMulti 200 SB units
RX and RX-P are modern counter-flow exchangers with fins made of durable aluminum and plastic. The counter-flow exchanger is the successor to the less
efficient cross-flow exchanger. The counter-flow exchanger does not transmit moisture or odors. Its efficiency exceeds 95%.
It is thanks to these properties, together with the tested tightness of each manufactured piece, that it finds its use both in heat recovery units of passive houses and in industrial applications.
- Efficiency up to over 95%
- Excellent value for money
- The best balance between pressure loss and efficiency
- Specially developed fin geometry for optimal heat transfer properties
- 100% leak testing
- Double seam technology for the entire product line = best tightness on the market
- Material: aluminum
- Eurovent, ILH, TÜV, EAC, QMS, OHMS, EMS certifications
This exchanger is dimensionally identical to the recuperators in Vallox ValloMulti 200 SB recuperation units. However, this is not an original spare part supplied and installed by the unit manufacturer, so its use is at the discretion of the RJ user.
 |
|
 |
|
Data sheet
- Warranty length
- 36 months
- EUROVENT certification:
- YES
- Slat material:
- Aluminum
- Sheathing material:
- Aluminum
- Operating temperature [°C]
- From -20 to +80
- Country of origin
- EU
RECUTECH are equipped with the latest enthalpic membrane METALPIC. They excel in top-class heat and humidity recovery, high resistance to pressure differences, and long service life. They are among the most advanced enthalpic heat exchangers currently available on the market.
ZERN are fully plastic enthalpic heat exchangers, very efficient, with slightly better moisture transfer, but with higher pressure loss.
No, never block the condensate drain.
Even though enthalpic heat exchangers produce only a minimal amount of condensate due to moisture transfer, in severe frost and specific humidity conditions, condensate can still occur. Blocking the drain could cause irreversible damage to your unit.
Since an enthalpic heat exchanger also transfers humidity, it might seem that the risk of mold is higher. In reality, however, all moisture is carried away with the fresh air, so there is no risk of mold growth.
Our recommendation is to never switch off the unit during the winter months, so that moisture is continuously removed. If you still need to shut down the unit, remove the exchanger, rinse it with clean water, dry it thoroughly, and only then reinstall it.
Yes, installation is simple. Just follow the instructions provided with your unit. As with a standard exchanger, it needs to be removed occasionally for cleaning – the process is the same, except that you put the enthalpic exchanger back in instead.
No, caring for an enthalpic heat exchanger is no more demanding than for a standard one. Maintenance is described in the user manual and in our video guide. In short: first vacuum the exchanger with a soft brush attachment, then rinse it with clean water (max. 50 °C). Never use compressed air or a pressure washer.
After rinsing, allow all water to drain completely. Remaining moisture can be carefully blown out with a regular hairdryer, but always use cold air only. Once the exchanger is completely dry, place it back into the unit in the same orientation as before removal.
We do not recommend using chemicals for cleaning. Only if disinfection is absolutely necessary may a weak solution of peracetic acid (CH₃CO₃H) at 0.1–0.2% concentration be used, followed by very thorough rinsing with clean water.
Replacement exchanger for Vallox ValloMulti 200 SB units