We offer a wide range of enthalpy exchangers suitable for most heat recovery units. If you can't find the right model, don't hesitate to contact us – we will be happy to help!

Close

Duct fan VENTS VK 150/160, 505 m3/h.

Connection diameter 150 and 160 mm - two-stage flange

Max. output 505 m3/h.

Kč1,726
i
The amount of VAT applied is 0% for the country United States.
Quantity
In Stock

USE
  • VK fans are used for supply and exhaust ventilation systems of commercial, office and other premises.
  • They are compatible with circular air ducts Ø 100, 125, 150, 160, 200, 250 and 315 mm.
  • Thanks to their durable, corrosion-resistant plastic housing, these models are the perfect solution for installation in exhaust ventilation systems in wet areas such as bathrooms, kitchens, etc.
CONSTRUCTION
  • The fan casing is made of high-quality, durable plastic.
  • The fans are equipped with waterproof terminal blocks.
ENGINE
  • The centrifugal wheel with backward-curved blades is driven by a single-phase motor with an external rotor.
  • The motor is equipped with automatic overheating protection.
  • The motor is equipped with ball bearings for a long service life designed for at least 40,000 operating hours.
  • For precise characteristics, safe operation and low noise, each impeller is dynamically balanced during assembly.
  • The motor protection is IP 44.
SPEED CONTROL
  • The fan speed can be regulated using the VENTS RS-1-400 controller.
  • Several fans can be connected to one speed controller, provided that the total power and operating current do not exceed the parameters of the rated speed controller.
CONSTRUCTION
  • Electrical connection and installation must be carried out in accordance with the manual and the wiring diagram on the terminal board.
  • Mounting the fan is simple and is done using the wall or ceiling bracket included in the delivery.
  • Fans can be installed at any angle

PRODUCT VIDEO

Clipping3.PNG

Data sheet

Warranty length
24 months
EC motor
NO
Sound pressure [dB/3m]
42
Diameter [mm]
150 and 160 (two-stage flange)
Weight [kg]
2.45
Rated current [A]
0.35
Protection [IP]
X4
Ball bearings
YES
Power supply [V/Hz]
230/50
Max. speed [min]
2725
Power consumption [W]
80
Air flow [m3/h]
505
Operating temperature [°C]
Max. 55
    Can I block the condensate drain if I replace a standard heat exchanger with an enthalpic one?

    No, never block the condensate drain.

    Even though enthalpic heat exchangers produce only a minimal amount of condensate due to moisture transfer, in severe frost and specific humidity conditions, condensate can still occur. Blocking the drain could cause irreversible damage to your unit.

    Are you satisfied with this article? Usefulness of the article: 0 / 0
    No